Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord.
The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
See also:
Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be
enabled or disabled as follows:
• For vehicles equipped with the Electronic Vehicle
Information Center (EVIC), refer to “Electronic Vehicle
...
Installing The Soft Top
NOTE: The following procedures are for first time set up only. For future
soft top procedures, refer to “Soft Top” in this section.
1. Locate and remove the following items prior to hard top re ...
Exhaust System
The best protection against carbon monoxide entry into the vehicle body is a
properly maintained engine exhaust system.
If you notice a change in the sound of the exhaust system; or if the exhaust ...