See also:

Programming A Non-Rolling Code
For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...

Road Tire Installation
1. Mount the road tire on the axle. 2. Install the remaining lug nuts with the cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts. WARNING! To avoid the risk of forcing the ...

Rear Hard Top Removal
1. Remove both front panels. Refer to “Front Panel(s) Removal” in this section. 2. Open both doors. 3. Remove the two Torx head screws that secure the hard top at the B-pillar (near the top of ...