Engine Oil Change Indicator System
Oil Change Due
Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Due” message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position or cycle the ignition to the ON/RUN position if equipped with Keyless Enter-N-Go. To turn off the message temporarily, press and release the MENU button.
To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure.
Vehicles Equipped With Keyless Enter-N-Go
1. Without pressing the brake pedal, push the ENGINE START/STOP button and cycle the ignition to the ON/ RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pressing the brake pedal, push the ENGINE START/STOP button once to return the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the ON/RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.
See also:
To Open And Close The Hood
Release both the hood latches.
Hood Latch
Raise the hood and locate the safety latch, located in the middle of the hood
opening. Push the latch to the left side of the vehicle, to open the hood. ...
Voice Command
• For best performance, adjust the rearview mirror to provide at least 1⁄2 in
(1 cm) gap between the overhead console (if equipped) and the mirror.
• Always wait for the beep before speak ...
Instrument Cluster Descriptions
1. Fuel Gauge
The pointer shows the level of fuel in the fuel tank when the ignition switch
is in the ON/RUN position.
2. Charging System Light
This light shows the status of the electrical cha ...