Adding Coolant
Your vehicle has been built with an improved engine coolant (antifreeze) that allows extended maintenance intervals. This engine coolant (antifreeze) can be used up to 5 Years or 104,000 miles (169 000 km) before replacement.
To prevent reducing this extended maintenance period, it is important that you use the same engine coolant (antifreeze) throughout the life of your vehicle.
Please review these recommendations for using Hybrid Organic Additive Technology (HOAT) engine coolant (antifreeze).
When adding engine coolant (antifreeze):
• The manufacturer recommends using MOPAR Antifreeze/ Coolant 5–Year/100,000 Mile Formula HOAT (Hybrid Organic Additive Technology) or equivalent.
• Mix a minimum solution of 50% HOAT engine coolant (antifreeze) and distilled water. Use higher concentrations (not to exceed 70%) if temperatures below -34°F (-37°C) are anticipated.
• Use only high purity water such as distilled or deionized water when mixing the water/engine coolant (antifreeze) solution. The use of lower quality water will reduce the amount of corrosion protection in the engine cooling system.
Please note that it is the owner’s responsibility to maintain the proper level of protection against freezing according to the temperatures occurring in the area where the vehicle is operated.
NOTE: Mixing engine coolant (antifreeze) types will decrease the life of the engine coolant (antifreeze) and will require more frequent engine coolant (antifreeze) changes.
See also:
Replacement Parts
Use of genuine MOPAR parts for normal/scheduled
maintenance and repairs is highly recommended to ensure
the designed performance. Damage or failures
caused by the use of non-MOPAR parts for main ...
Headlamps with Wipers (Available with Auto Headlights Only)
When on is selected, and the headlight switch is in the AUTO position, the headlights
will turn on approximately 10 seconds after the wipers are turned on. If the headlights
were turned on by this ...
Side Step Removal – If Equipped
NOTE: Prior to off-road usage, the side steps should be removed to prevent
damage.
1. Remove the two nuts from the bodyside.
2. Remove one bolt from the underside of the vehicle.
3. Remove th ...


