Voice Training

For users experiencing difficulty with the system recognizing their voice commands or numbers, the Uconnect™ Phone Voice Training feature may be used. To enter this training mode, follow one of the two following procedures:

From outside the Uconnect™ Phone mode (e.g., from radio mode):

• Press and hold the five seconds until the session begins, or, • Press the button for five seconds until the session begins, or, • Press the System Training, or Start Voice Training” command. button and say the “Voice Training, System Training, or Start Voice Training” command.

You can either press the Uconnect™ Phone button to restore the factory setting or repeat the words and phrases when prompted by the Uconnect™ Phone. For best results, the Voice Training session should be completed when the vehicle is parked with the engine running, all windows closed, and the blower fan switched off.

This procedure may be repeated with a new user. The system will adapt to the last trained voice only.

    See also:

    Hazard Warning Flashers
    The Hazard Warning flasher switch is located in the switch bank below the climate controls. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional ...

    SAFETY
    The Wrangler Unlimited has two sets of lower Latch anchors in the outboard seats. The outer Latch anchors were easy to use, but the inner anchors in both positions sat right behind the seat belt b ...

    Manual Lumbar Support — If Equipped
    For models equipped with manual lumbar the support lever is located on the inboard side of the seat. Turn the lever downward to increase and upward to decrease the desired amount of lumbar suppo ...