Front Panel(s) Installation
NOTE: Set the panels on the windshield frame so that there is no overhang. Also, make sure that the panels are sitting flush with the body.
1. Install the right panel first, then the left panel.
2. Reinstall the panel(s) using the same steps for removal in reverse order.
See also:
Manual Lumbar Support — If Equipped
For models equipped with manual lumbar the support
lever is located on the inboard side of the seat. Turn the
lever downward to increase and upward to decrease the
desired amount of lumbar suppo ...
Lap/Shoulder Belt Operating Instructions
1. Enter the vehicle and close the door. Sit back and adjust the seat.
2. The seat belt latch plate is above the back of the front seat and next to
your arm in the rear seat. Grasp the latch plate ...
Tire Pressure Monitor System (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the
driver of a low tire pressure based on the vehicle recommended
cold placard pressure.
The tire pressure will vary with temperature by about
...


