Drain
First remove the fill plug (B), then the drain plug (C). The recommended tightening torque for the drain and fill plugs is 15 to 25 ft lbs (20 to 34 N·m).
CAUTION!
When replacing the plugs, do not overtighten them.
You could damage them and cause them to leak.
See also:
Windshield Washers
To use the washer, pull the lever toward you and hold while spray is desired.
If the lever is pulled while in the delay range, the wiper will start and continue
to operate for two or three wipe cy ...
Quadra-Drive II System – If Equipped
The optional Quadra-Drive II System features two
torque transfer couplings. The couplings include an
Electronic Limited-Slip Differential (ELSD) rear axle and
the Quadra-Trac II transfer case. T ...
Media Center 130 (Sales Code RES)
NOTE: The radio sales code is located on the lower right
side of the radio faceplate.
Media Center 130 (RES) ...