Center High-Mounted Stop Lamp (CHMSL)
The stop lamp is mounted on a bracket that extends upward from the tailgate behind the spare tire. If service is needed, obtain the LED/Cover Assembly from your local authorized dealer.
1. Remove the spare tire.
2. Remove the four screws holding the lens/cover in place on the spare tire carrier.
3. Disconnect the wire harness from the back of the LED cover.
See also:
Adding Washer Fluid
The windshield and rear window washers share the same
fluid reservoir. The fluid reservoir is located in the front
of the engine compartment. Be sure to check the fluid
level in the reservoir at ...
Smooth, quiet ride
But most people won't get out into the wild with the Unlimited and they'll
enjoy it just the same on the highway. Jeep added a few acoustic improvements to
make the ride quieter, though those are ...
Power Steering Fluid Check
Checking the power steering fluid level at a defined service interval is not
required. The fluid should only be checked if a leak is suspected, abnormal noises
are apparent, and/or the system is n ...