Memory Position Recall

NOTE:
• For vehicles equipped with an automatic transmission, the vehicle must be in PARK to recall memory positions.

If a recall is attempted when the vehicle is not in PARK, a message will display in the EVIC, if equipped.

• For vehicles equipped with a manual transmission, the vehicle speed must be at 0 mph (0 km/h) to recall memory positions. If a recall is attempted with the vehicle speed above 0 mph (0 km/h), a message will display in the EVIC, if equipped.

To recall the memory settings for driver one, press MEMORY button number 1 or the UNLOCK button on the RKE transmitter linked to memory position 1.

To recall the memory setting for driver two, press MEMORY button number 2 or the UNLOCK button on the RKE transmitter linked to memory position 2.

A recall can be cancelled by pressing any of the MEMORY buttons (S, 1, or 2) during a recall. When a recall is cancelled, the driver seat will stop moving. A delay of one second will occur before another recall can be selected.

    See also:

    Rear Cupholders
    The rear cupholders are located on the back of the center console. Rear Cupholders ...

    Operating Instructions — Radio Mode
    NOTE: The ignition switch must be in the ON or ACC position to operate the radio. ...

    Flash-To-Pass
    You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...