Front Fog Lamp

1. Open the hood.

2. Reach behind the headlamp housing to access the bulb.

3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing.

4. Pull the bulb out of the socket and insert the replacement bulb.

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

5. Install the bulb and socket assembly into the into the fog lamp housing, and rotate the connector clockwise to lock it in place.

6. Close the hood.

    See also:

    Driver’s Power Seat — If Equipped
    The power seat switch is located on the outboard side of the seat near the floor. Use this switch to move the seat up or down, forward or rearward or to tilt the seat. Power Seat Switch Adjust ...

    Delete/Erase “All” Uconnect™ Phonebook Entries
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Phonebook Erase All”. • The Uconnect™ Phone will ask you to verify that you wish to delete all t ...

    Loading
    The vehicle maximum load on the tire must not exceed the load carrying capacity of the tire on your vehicle. You will not exceed the tire’s load carrying capacity if you adhere to the loading ...