List Paired Mobile Phone Names

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.

• When prompted, say “List Phones”.

• The Uconnect™ Phone will play the phone names of all paired mobile phones in order from the highest to the lowest priority. To “Select” or “Delete” a paired phone being announced, press the button and say “Select” or “Delete”. Also, see the next two sections for an alternate way to “Select” or “Delete” a paired phone.

    See also:

    Engine Block Heater — If Equipped
    The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...

    Removing ACC Sensor For Off-Roading
    NOTE: When off-roading, it may be advisable to remove the ACC sensor. The sensor is located behind the front lower grille in the center of the vehicle. After removing the lower fascia, you may r ...

    To Exit Remote Start Mode And Drive The Vehicle
    Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into ...