Keyless Enter-N-Go Display — If Equipped
When the ENGINE START/STOP button is pressed to change ignition switch positions, the Keyless Enter-N-Go icon momentarily appears in the lower right corner of the EVIC display showing the new ignition switch position.
Refer to “Keyless Enter-N-Go” in “Starting And Operating” for more information.
NOTE: Under certain conditions, the display may be superseded by another display of higher priority. But when the ignition switch position is changed, the display always re-appears.
See also:
Electrical Power Outlet
Your vehicle is equipped with a fused 12 Volt (13 Amp)
power outlet. This power outlet is located on the instrument
panel, below the climate controls. It has power
available when the ignition sw ...
Towing Without The Ignition Key Fob
Special care must be taken when the vehicle is towed with the ignition in the
LOCK/OFF position. The only approved method of towing without the ignition key is
with a flatbed truck. Proper towing ...
Reset
• press the button.
• After the “Ready” prompt, and the following beep, say
“Setup”, then “Reset”.
This will delete all phone pairing, phone book entries,
and other settings in ...


