Towing Requirements – Trailer Lights And Wiring
Whenever you pull a trailer, regardless of the trailer size, stop lights and turn signals on the trailer are required for motoring safety.
The Trailer Tow Package includes a seven–pin connector at the rear of the vehicle and a four-pin harness located under the rear bumper. The four-pin harness must be unclipped before use. Use a factory-approved trailer harness and connector.
The electrical connections are all complete to the vehicle but you must mate the harness to a trailer connector.
Refer to the following illustrations.
Four-Pin Connector
1 — Female Pins
2 — Male Pin
3 — Ground
4 — Park
5 — Left Stop/Turn
6 — Right Stop/Turn
Seven-Pin Connector
1 — Battery
2 — Backup Lamps
3 — Right Stop/Turn
4 — Electric Brakes
5 — Ground
6 — Left Stop/Turn
7 — Running Lamps
See also:
EXTERIOR
The Wrangler Unlimited is definitely a fun vehicle to look at, and I like to
think that other people wished they had as fun a car as I did. Well, for a week
anyway. This SUV has a distinctive look ...
Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction
lever toward the steering wheel. This will turn on the high beam headlights until
the lever is released. ...
Towing Without The Ignition Key Fob
Special care must be taken when the vehicle is towed with the ignition in the
LOCK/OFF position. The only approved method of towing without the ignition key is
with a flatbed truck. Proper towing ...