To Set The Variance
Start the engine and leave the transmission gear selector lever in the PARK position. Press and hold the RESET button on the steering wheel (for approximately ten seconds) until the current variance zone number is displayed.
To change the zone, press and release the STEP button to increase the variance one step. Repeat as necessary until the desired variance is achieved.
NOTE: The factory default zone is 8. During programming, the zone value will wrap around from zone 15 to zone 1.
See also:
Publication Order Forms
To order the following manuals, you may use either the
website or the phone numbers listed below. Visa, Mastercard,
American Express, and Discover orders are accepted.
If you prefer mailing your ...
Fuel Requirements
Your vehicle will operate on both unleaded gasoline with
an octane rating of 87, or E-85 fuel, or any mixture of
these two. For best results, a refueling pattern that
alternates between E-85 and ...
Automatic Transmission
The DRIVE range can be selected when towing. However,
if frequent shifting occurs while in this range, the
TOW/HAUL mode (if equipped), or a lower gear range,
should be selected.
NOTE: Using th ...